1. Low hardness silicone products (30 degrees) of the plastic molding, it is easily affected by mold temperature and other factors
Affect the appearance of bubbles (including wind) and other undesirable phenomena, if the silicone products require body color or translucent color, it is easy to form a lot of white spots inside the silicone products.
2. Appropriate to raise the mold temperature after the bubble (including wind) and white spots of the bad, but
Is the edge of the silicone products began to appear fragmentation, that is, the phenomenon of explosive silicone products. In such circumstances, it is completely formed a bad cycle, the mold temperature increase on the edge of the explosion, the mold temperature decreases appear on the bubble (wind) and white point of bad phenomenon.
3, silicone molding mold self-dismantling knife edge, too sharp or burr is caused by
Explosion edge of the incentive.
Silicone production lines
Hardness of the silicone products appear explosive this situation?
Established in 2000, Jinyu is located in Dongxiang Industrial Zone, Da Lingshan, Dongguan City, where it founded the silicone and PVC trademark gift production equipment. Jinyu has developed fully automatic automatic dispenser, silicon Plastic machine, hydraulic machine, KPU shoe machine and finally realized intelligent unmanned workshop production lines, Jinyu Machine Factory automation equipment can do you save, power, provincial management. Jinyu welcome new and old visitors, choose Jinyu.
www.jinyumachine.en.alibaba.com
WhatsApp：+8613829130058
No comments:
Post a Comment